5834-4 HIGH SECURITY MODE KEYFOB

 

 

Programming

• Each 5834-4 transmitter has two unique serial numbers assigned during Loop Numbers for the 5834-4 Buttons manufacture.Each button on the unit also has a distinct "loop" number (refer to the Loop Number at right) that you must program into the control panel during installation.
• Assign each button to an individual zone and designate the Input Type as "BR" (Button Type).
• When prompted for the serial number, press and release the appropriate button(s) twice, or, manually enter the serial number at the keypad.

NOTE: Serial #2 is one (1) digit higher than serial #1, which is printed on the rear of the transmitter.

                                                                    Hand Model Cliff S.

USING HIGH SECURITY MODE IN COMPATIBLE RECEIVERS AND LOCALLY IN AN RF KEYPAD (eg., 6150RF) 

If used with LYNXR/Quick Connect Series controls earlier than Revision 13.1, Standard Mode must be selected. First select High Security mode, then activate it. Activation syncs the key fob with the security system.

• 1. Select High Security mode: Mode Simultaneously hold down for 5 secs… A - C - D (LED flashes Red when transmitting) High-Security B - C - D (LED flashes Green when transmitting) Standard
• 2. Activate High Security mode: • if the key fob is enrolled into the panel, put the security system into Go/No Go Mode 
• 3. If the key fob is enrolled locally into a 6150RF, go to Step 3 of 6150RF “Programming WITH Local Wireless Keys”, then press the appropriate set of buttons as follows: Serial Number Simultaneously hold down until beeps sound… A - B - C buttons (system beeps twice to confirm) 1 A - B - D buttons (system beeps twice to confirm)
 
Please see below for instructions provided by our small business team.
ENTER INSTALLER CODE #8 THEN HOLD ALL THREE BUTTONS (NOT PANIC) AT ONCE AND YOU WILL GET TWO BEEPS. THIS CONCLUDES THE PROGRAMMING